 |
|||
 |
 |
View Basket | |
 |
>>Checkout | ||
Cooling Vests, T-shirts, Thermals, Headwear, Blankets and CoolChampions Animal Cooling Apparel |
|
||
| ||||||||||||||
|
Activating Silver Eagle Cooling Products | |||||||||||||||||||||||||||||||||||||||||||
|
Water Activation Amounts (cups) |
||
| Product |
Size |
Water Amount |
| Classic Vest | Medium-Large |
1 1/2 |
| X-L - 2XL |
1 3/4 |
|
| 3XL - 4XL |
2 1/4 |
|
| Women’s Classic Vest | Small-Medium |
3/4 |
| Large-XL |
1 |
|
| Women’s Tailored Vest | Small-Large |
1 |
| XL - 2XL |
1 3/4 |
|
| 3XL - 4XL |
2 |
|
| Zip-Front Vest | Small-Medium |
1 3/4 |
| Large-XL |
2 |
|
| 2X - 3X |
2 1/4 |
|
| 4X |
2/1/2 |
|
| Camo Vest | Large-XL |
2 |
| Pullover Vest | One Size |
1 3/4 |
|
K9 Vest |
All Sizes |
2 1/2 |
Package Activation Method
Silver Eagle cooling vests and blankets are packaged in a zip-lock activation bag. The activation method described below is a quick and easy way to activate your garment.
Remove the paper insert from the package.
Place the folded garment into the bag.
Pour the correct amount of water indicated in the Water Activation Amount Chart (to the left) for your size and type of garment into the activation bag with the garment. The amount of water needed to activate the vest will depend on the size and type of garment.
Zip-lock the top of the activation package.
Shake bag slightly and lay flat for 15 minutes.
Remove the garment from the activation package. If necessary, gently wring the garment or roll it in a towel to remove any excess water.
Wipe off any excess moisture from the inner lining (the side that you wear next to your body) with a paper towel or dry cloth.
The washing machine is a great way to activate Silver Eagle products. Simply run your vest, blanket, or headwear through the rinse-and-spin cycle without detergent. When your machine stops, your product is ready to use immediately or to store in an activation pouch for use later in the day.
Note: DO NOT leave activated products in the activation bag for more than 24 hours.
Soak Silver Eagle products in a sink or container of cool water for 5 minutes to charge the special absorbent fibres. Because the middle layer of our fabric has finite water-absorbing capabilities, you cannot over-soak or over-activate Silver Eagle products.
Remove excess water by gently wringing out the garment or rolling it in a towel.
Hang on hanger for a few minutes to let moisture drain to the bottom of garment, re-wring or re-roll in the towel.
Towel dry the inner lining and outer shell.
Silver Eagle caps, hats and Do-Rags are activated by soaking them in tap water. For maximum cooling time, allow them to absorb water into the fabric's core for 3 to 5 minutes. Wring out excessive moisture and towel-dry the inner surface if desired.
For shorter periods of cooling, turn the gear over and pour a limited amount of water into the liner, allowing it to fully soak into the fabric's core.
Although you may completely wring out excess water from the headgear, the material offers increased and prolonged effectiveness if aggressive wringing is avoided.
The Silver Eagle Cap's bill is made of a quality plastic that is not affected by water.
Activation:
Package Activation:
***You may also keep the moistened neck shade in the activation bag until ready to use, but do lot leave it in the bag for more than 24 hours.
Faucet activation:
Pre-treat stains with stain remover.
Pre-soak 5 minutes before adding a mild detergent.
Wash as normal on gentle cycle. DO NOT USE CHLORINE BLEACH.
Line dry or machine dry on low heat.
Thoroughly dry product before storing.
Do not freeze Silver Eagle Outfitters products.
| ||||||||||||||||||||||||
